#Night shift app for mac install#

#Night shift app for mac install#

Follow the onscreen instructions to download and install Java. If the computer and device both recognize that they are connected, then the problem probably is related to your Java installation.

When the device is plugged in, the computer should recognize that a device is plugged in and should automatically open an AutoPlay window which shows the drive where the device was plugged.

Try using a different cable to connect the device and the computer, and start over at step 1.

If USB port is good and battery is charged, you could have a bad cable.

Try plugging cable into a different USB port and start over at step 1.

If battery is charged, USB port on your computer may be bad.

Once device vibrates/light is on, unplug from computer and start over at step 1.

Battery may be dead – leave device plugged into the computer until device vibrates and light turns on, it could take 15 minutes for this to happen.

When device is first plugged into the computer, the device should vibrate and the light on the device should be solid green.

Plug device into the computer using the USB cable.

Clear Study History – Erase all historical data from the device.įirst, check that the device is plugged in correctly and recognized by the computer.

Restore Study Data – Loads the study data that was on the device at the time of the last firmware upgrade back onto the device.

Once baseline night is recorded, it will remain on the device until Clear Study History is selected. All recordings made after the third night of a trial will have feedback.

Trial – is used by clinicians to establish a baseline with no feedback for one night, and with feedback for two nights.

No Feedback – turns feedback off for the entire night and all subsequent nights.

After 30 minutes – turns positional feedback on 30 minutes after device is turned on.

After 15 minutes – turns positional feedback on 15 minutes after device is turned on.

Manage Your Night Shift – Start Position Feedback can be used to adjust the feedback settings for study acquisition.

The mange device page is used to change the positional feedback setting and to manage your Night Shift device.